3D Interactive PDF Version Available
Click Diagram To View!
(Requires Free Acrobat Reader 7.0.07 or better)

Key Features
• Inner ridge trim can be flat or profiled, but in either case
  must be sealed at laps and at joints with liner.
• Insulation must be continuous over the ridge.
• If canister applied insulation is used, it will also act as an air barrier.
• The ridge flashing should be fixed through, or upslope from the filler.
• The filler must be kept clear of panel fasteners, ideally downslope.
• All fixings and seals to manufacturer's recommendations.
• Thermal bridge should always be small. (Low Y value)

Built-Up Systems Details

Ridge - Twin Skin
Corner - Twin Skin
Window/Door Jamb - Twin Skin
Window/Door Head - Twin Skin
Window Sill - Twin Skin
Eaves - Twin Skin
Sill - Twin Skin
Verge - Twin Skin
Parapet Top - Twin Skin
Parapet Verge - Twin Skin
Parapet Gutter - Twin Skin
Overhanging Eaves - Twin Skin
Overhanging Eaves - Twin Skin (No Liner Bridge)
Overhanging Verge - Twin Skin
Hip - Twin Skin
Hip Valley - Twin Skin
Valley Gutter - Twin Skin

Composite Panel Systems Details

Ridge - Composite Panels
Corner - Composite Panels
Window/Door Jamb - Composite Panels
Window/Door Head - Composite Panels
Window Sill - Composite Panels
Eaves - Composite Panels
Sill - Composite Panels
Verge - Composite Panels
Parapet Top - Composite Panels
Parapet Verge - Composite Panels
Parapet Gutter - Composite Panels
Overhanging Eaves - Composite Panels
Overhanging Verge - Composite Panels
Hip - Composite Panels
Hip Valley - Composite Panels
Valley Gutter - Composite Panels