3D Interactive PDF Version Available
Click Diagram To View!
(Requires Free Acrobat Reader 7.0.07 or better)

Key Features
• Inner trim is air seal to cladding, so lap joints must be sealed and fixed.
• Parapet and roof cladding liner must be effectively sealed to the inner trim, using fasteners to compress seal/secure joint as necessary.
• Roof outer sheet and spacers must terminate approximately in line with parapet outer sheet.
• Insulation to fill cavity at junction.
• Verge flashing should fix to outer sheet of parapet cladding, and not cut through the insulation to the liner.
• Parapet outer sheet/panel has to be rake cut on site. Fit with 10 mm gap to verge flashing.
• Thermal bridging will be low.

Built-Up Systems Details

Ridge - Twin Skin
Corner - Twin Skin
Window/Door Jamb - Twin Skin
Window/Door Head - Twin Skin
Window Sill - Twin Skin
Eaves - Twin Skin
Sill - Twin Skin
Verge - Twin Skin
Parapet Top - Twin Skin
Parapet Verge - Twin Skin
Parapet Gutter - Twin Skin
Overhanging Eaves - Twin Skin
Overhanging Eaves - Twin Skin (No Liner Bridge)
Overhanging Verge - Twin Skin
Hip - Twin Skin
Hip Valley - Twin Skin
Valley Gutter - Twin Skin

Composite Panel Systems Details

Ridge - Composite Panels
Corner - Composite Panels
Window/Door Jamb - Composite Panels
Window/Door Head - Composite Panels
Window Sill - Composite Panels
Eaves - Composite Panels
Sill - Composite Panels
Verge - Composite Panels
Parapet Top - Composite Panels
Parapet Verge - Composite Panels
Parapet Gutter - Composite Panels
Overhanging Eaves - Composite Panels
Overhanging Verge - Composite Panels
Hip - Composite Panels
Hip Valley - Composite Panels
Valley Gutter - Composite Panels