3D Interactive PDF Version Available
Click Diagram To View!
(Requires Free Acrobat Reader 7.0.07 or better)

Key Features
• Gutter thickness and thermal bridging detail could vary, depending on manufacturer.
• Ideally, the gutter outer surface should not bridge insulation.
• Cladding details will minimise bridging due to cladding, no matter what gutter design is used.
• Liner must be air sealed to gutter legs on both the roof and parapet side.
• Roof liner must terminate approximately in line with purlin web, to avoid bridging gutter insulation.
• Insulation must fill to gutter junctions leaving no voids.
• Flashings must not bridge insulation.

Built-Up Systems Details

Ridge - Twin Skin
Corner - Twin Skin
Window/Door Jamb - Twin Skin
Window/Door Head - Twin Skin
Window Sill - Twin Skin
Eaves - Twin Skin
Sill - Twin Skin
Verge - Twin Skin
Parapet Top - Twin Skin
Parapet Verge - Twin Skin
Parapet Gutter - Twin Skin
Overhanging Eaves - Twin Skin
Overhanging Eaves - Twin Skin (No Liner Bridge)
Overhanging Verge - Twin Skin
Hip - Twin Skin
Hip Valley - Twin Skin
Valley Gutter - Twin Skin

Composite Panel Systems Details

Ridge - Composite Panels
Corner - Composite Panels
Window/Door Jamb - Composite Panels
Window/Door Head - Composite Panels
Window Sill - Composite Panels
Eaves - Composite Panels
Sill - Composite Panels
Verge - Composite Panels
Parapet Top - Composite Panels
Parapet Verge - Composite Panels
Parapet Gutter - Composite Panels
Overhanging Eaves - Composite Panels
Overhanging Verge - Composite Panels
Hip - Composite Panels
Hip Valley - Composite Panels
Valley Gutter - Composite Panels